anboli
Full Member level 2
Hi to all,
I had interfaced the DS1307ic with my PIC controller. I getting all the values from the RTC IC, but while accessing the square wave, its not giving the proper 1Hz pulse, instead of it gives too much of pulses during the ON time of the signal but not in thr OFF time.
i given 4.7K Pull up with 3.3v,
VCC of the IC is 5V.
Please give any solution to get the proper square wave out from the DS1307 IC.
I had interfaced the DS1307ic with my PIC controller. I getting all the values from the RTC IC, but while accessing the square wave, its not giving the proper 1Hz pulse, instead of it gives too much of pulses during the ON time of the signal but not in thr OFF time.
i given 4.7K Pull up with 3.3v,
VCC of the IC is 5V.
Please give any solution to get the proper square wave out from the DS1307 IC.