m11vajju
Newbie level 6
hi,
I am using microwave office for simulating filter. I have done with schematic and results are ok. I am trying to use an extraction for converting schematic to EM.
1. How to extract Ground from schematic to Em?
2. How to extract ports from schematic?
I tried converting schematic to em but results are not same as schematic. I am getting warning as Numerically instability detected while de-embedding port 1 and 2 ,analytic de-embedding was applied.
I am using microwave office for simulating filter. I have done with schematic and results are ok. I am trying to use an extraction for converting schematic to EM.
1. How to extract Ground from schematic to Em?
2. How to extract ports from schematic?
I tried converting schematic to em but results are not same as schematic. I am getting warning as Numerically instability detected while de-embedding port 1 and 2 ,analytic de-embedding was applied.