Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Biconical antenna - CST model (Antenna Magus)

Status
Not open for further replies.
Q

qwery71

Newbie level 1
Joined
Oct 30, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
Hello,

I'm quite new to CST Microwave Studio and I'm not sure if my model of biconical antenna is correct because I got strange simulation results (VSWR).
I noticed on internet that there is a model of EMC wire biconical antenna in Antenna Magus design software (which I dont' own). I would be very grateful if u guys could send me CST model of this antenna exported from Antenna Magus (or any other model if you have one).

Thanks.

[email address deleted]
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top