tompham
Full Member level 2
Hi all
I am simulating slew rate of fully op amp. I set up as the way in picture below and simulatiion look ok, but I have a question about resistors value in simulation. How to decide value of resistor value? If R too large the current from vin to input of opamp will be 0 ---> the set up become ideal case (vin = vin_opamp = vout_opamp)? Thanks
I am simulating slew rate of fully op amp. I set up as the way in picture below and simulatiion look ok, but I have a question about resistors value in simulation. How to decide value of resistor value? If R too large the current from vin to input of opamp will be 0 ---> the set up become ideal case (vin = vin_opamp = vout_opamp)? Thanks