Sujit Nagarajan
Newbie level 1
Hi everyone,
Just doing a project for uni and have created a loop antenna on HFSS. I'm not at a stage to impedance match the antenna and am using a smith chart software. I obtained a impedance from HFSS something around (2 - 200j)ohms and am wondering when I impedance match to a 50 ohm terminator is this the load impedance or source impedance. I am trying to use the antenna as a receiver only.
Any insight would be much appreciated,
Thanks
Just doing a project for uni and have created a loop antenna on HFSS. I'm not at a stage to impedance match the antenna and am using a smith chart software. I obtained a impedance from HFSS something around (2 - 200j)ohms and am wondering when I impedance match to a 50 ohm terminator is this the load impedance or source impedance. I am trying to use the antenna as a receiver only.
Any insight would be much appreciated,
Thanks