Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

When to use ioupdate signal in ad9910 spi mode

Status
Not open for further replies.
K

kishorevarma.k

Newbie level 2
Joined
Sep 19, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
Hi


i am looking to configure ad9910 in spi mode,i want to know how to use ioupdate pin once after sending 8bit address bits or 32bit cfr register bits

can somebody let me know
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top