Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

USB to UART converter

Status
Not open for further replies.
H

harii07

Junior Member level 3
Joined
Aug 10, 2012
Messages
30
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,462
Dear All
I have made USB to RS232 board for my own purpose. Is PL2303HX device need to programmed or just IC itself OK.
 

No need for programming, it will work
 

Dear Nanthu
Thanks for your reply. Should i use EEPROM?

I surf for PL2303HX circuit but i can find somany schematic. please suggest proper schematic for PL2303HX.
 

I think there is a need for eeprom. Confirm with datasheet.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top