Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] what are steps to see polarization in HFSS v 11 ( plz rpy early) ?

Status
Not open for further replies.
C

Chetali

Member level 1
Joined
Apr 14, 2013
Messages
32
Helped
2
Reputation
4
Reaction score
3
Trophy points
1,288
Activity points
1,447
i am following this steps,

Result > far field report > radiation pattern > gainLX for Eplane copolarization.

but nt getting results.:?:

Plz any1 tell me am i right?????????


& wt r steps to see H Plane polarization ???????:?:

Please reply as early as possible.


Thanking u in anticipation
 

what do you understand by gainLX plot? are you doing the sweep analysis while plotting the curves with frequency for set theta and phi?
 

ashish.mw said:
what do you understand by gainLX plot? are you doing the sweep analysis while plotting the curves with frequency for set theta and phi?
Click to expand...

yes, im using sweep.
but using this im getting only 180 degree results, other 180 remaining blank.

i have seen the co & cross polarization radiation pattern shows complete 360 degree.

Thanks in advance
 

hi,

To see linear polarization E plane result > Far field report > radiation pattern

set theta = all , phi = 0
gain, in category select gain phi n theta both.

same step to H plane only set phi = 90.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top