Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am designing signle ended mixer i match if and lo ports by lumped components but rf port is not matching simultaneously so how i match three ports simultaneously.??
Apparently Varuniyengar does not understand my English. One-diode mixers are almost never used as their one diode cannot be matched for all three ports. Balanced mixers can be matched well.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
