Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Make sure it is not hidden:
If you plan to use a ground plane, you can hide ratsnest lines for the GND net by selecting View → Connections → Hide Net and then clicking a pin connected to GND.
Hi,
It could be two things,
Go View/Connections/Show All
Or
You have asigned GND layer as an Internal plane layer in which the Through holes Connected to gnd will not show Rat nests but The SMDs should still show gnd rat nests.
thanks,
keyur
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.