Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pure CMOS analog design can use zener diode or not ??

Status
Not open for further replies.
A

andy2000a

Advanced Member level 2
Joined
Jul 18, 2001
Messages
597
Helped
14
Reputation
28
Reaction score
8
Trophy points
1,298
Activity points
5,298
we usually use MOS_diode , but have any method use
P-N junction make a diode in CMOS design

and another problem is , CMOS can use reverse junction for zener diode ?
and zener volt can be measure/simulation by hspice ??
 

Yes, we can use the PN juction as a diode.
For zener diode, it is few for pure cmos circuit.
 

I'm sure there will be processes around that offer zener diodes on chip, but this extra option will cost you a lot money for your chip. It is up to you if this extra cost is needed. There are other ways to make stable on-chip voltage or current references. And if their performance is not as good as you wish it would be, why not use an external reference? Perhaps that's a more cost-effective way to do it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top