Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys , In the tutorials it is written that the wave port size should not exceed lambda/2 in any dimension but also its width should not be less than 3(2g+w).
In my case I have lambda=25mm
g=0.23mm
w=8mm , all these for Zo=50 ohms.
Now my waveport width comes out to be 25.38mm,
but lambda/2=12.5mm.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
