rsrkrishna
Junior Member level 1
Hi
I am using spectre for simulations. Would it possible for me to run transient analysis with initial condition chosen form "at some point" from previous transient analysis.
To make it clear : I am trying to simulate a 60+GHz oscillator, its simulating fine but there is a phase shift of oscillations for each successive simulation. I would like to know if its possible to store all node voltages at certain point wrt time, when its oscillating, and use these voltages as initial condition - as all nodes will be set with initial conditions - I would like to do transient analysis.
Appreciate your help.
Regards
RSR Krishna
I am using spectre for simulations. Would it possible for me to run transient analysis with initial condition chosen form "at some point" from previous transient analysis.
To make it clear : I am trying to simulate a 60+GHz oscillator, its simulating fine but there is a phase shift of oscillations for each successive simulation. I would like to know if its possible to store all node voltages at certain point wrt time, when its oscillating, and use these voltages as initial condition - as all nodes will be set with initial conditions - I would like to do transient analysis.
Appreciate your help.
Regards
RSR Krishna