Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Which metal layer is used for Pre and Post route signals ?

Status
Not open for further replies.
C

cnnprem.eee

Newbie level 6
Joined
Mar 1, 2011
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Bangalore
Activity points
1,355
If i am using 9lm which metal layers are used for core ring , power straps and power rail?

Then clock and signal routing in which metal layer?
 

Normally power use the highest two metal layers which are the widest.
Clock is routed before signals which mean clock can use any layer it want to
signals are routed the last and use any metal resources left
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top