Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Did you check the crystal oscillator. how did you confirm that program is not executing.
You can check the oscillation in the oscilloscope to verify it
YOUR suggestion is works. the leed of crytal is broke while soldering. tomorrow i get new crystal and solder it.
Please suggest some good books for learning debugging hardware, as i am computer science student. i cannot see hardware problem unless told to do step by step
---------- Post added at 22:37 ---------- Previous post was at 22:35 ----------
why always you answer my posts. its really coinsidence.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.