+ Post New Thread
Results 1 to 4 of 4
  1. #1
    Newbie level 2
    Points: 526, Level: 4

    Join Date
    Jan 2010
    Location
    PA
    Posts
    2
    Helped
    0 / 0
    Points
    526
    Level
    4

    I need a Schmatic w/part list 12VDC to 220VAC, 60hz sine

    I need a schematic w/part list for a 12VDC to 220VAC, 60hz sine wave Inverter which will handle 8kw continious and a 10kw peak.

    •   AltAdvertisment

        
       

  2. #2
    Super Moderator
    Points: 253,869, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    44,233
    Helped
    13462 / 13462
    Points
    253,869
    Level
    100

    I need a Schmatic w/part list 12VDC to 220VAC, 60hz sine

    Oh, that's a peak current of about 1000 A (assuming a HV energy storage and no input ripple). Do you have a suitable battery to drive the inverter?



    •   AltAdvertisment

        
       

  3. #3
    Advanced Member level 5
    Points: 38,590, Level: 48
    Achievements:
    Created Album pictures Created Blog entry 7 years registered
    Tahmid's Avatar
    Join Date
    Jun 2008
    Location
    Silicon Valley, California, USA (from Dhaka, Bangladesh)
    Posts
    4,758
    Helped
    1797 / 1797
    Points
    38,590
    Level
    48
    Blog Entries
    22

    I need a Schmatic w/part list 12VDC to 220VAC, 60hz sine

    Hi,
    10kW is too much to drive from 12vdc. As FvM said, you'll require a peak current of about 1000A! Forgetting battery for the moment, what about the electronics. Even if the schematic is given to you, it's going to be quite difficult constructing it.
    Over here, for 7.5kw inverters, 96v-120v battery banks are used.



    •   AltAdvertisment

        
       

  4. #4
    Super Moderator
    Points: 253,869, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    44,233
    Helped
    13462 / 13462
    Points
    253,869
    Level
    100

    Re: I need a Schmatic w/part list 12VDC to 220VAC, 60hz sin

    Over here, for 7.5kw inverters, 96v-120v battery banks are used.
    Yes. You won't run a 10 kW inverter, even for a few minutes from less than about 10 batteries.



--[[ ]]--