Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question about matching network between FEM and ANT,thanks

Status
Not open for further replies.
I

iambbcat

Newbie level 4
Joined
May 26, 2003
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
51
I want to match an ANT to FEM , but I don;t know how to choice the matching network , the S11 measured is changing with FREQ ,and I can't find a network to keep all four FREQ of GSM and DCS inside the circle of SWR<3

can you tell me how to design the network ? :oops: thanks
 

Re: A question about matching network between FEM and ANT,th

To have a good match between Front End Module and antenna at all four GSM frequencies, the antenna itself shall have a good S11 at these frequencies.
S11 without any matching network shall be better than –10dB for frequencies between 824MHz to 960MHz and 1710MHz to 1990MHz. Probably the best antenna for this multiband application is PIF Antenna (Planar Inverted F). This antenna usually requires a simple L or T matching network.

regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top