Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

When I run Hspice, I have the following problem: no sh

Status
Not open for further replies.

danda821

Full Member level 2
Joined
Jun 18, 2002
Messages
139
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
1,083
hspice running -n

when I run Hspice, I have the following problem: no sh
Does anyone know what is wrong? Thank you
 

[help] Hspice installation

For RedHat or FC1,
1. Go to <$hspice_inst_dir>/bin/tcltk/RH72/
2. rm -rf tixwish
3. ln -s /usr/bin/tixwish8.1.8.3.1 tixwish

This should do it.

May try <$hspice_inst_dir>/bin/tcltk/linux/ if not working.
 

[help]run Hspice

Thank you, the problem is solved.
 

[help] Hspice installation

where could i get the linux version Hspice ? i only have a
version of 2001.2 but my license is for 2001.2 it could not boot up
 

Re: [help] Hspice installation

l can not open my Avanwaves???
 

Re: [help] Hspice installation

hhun said:
l can not open my Avanwaves???
Yes, because Hspice in Linux has not the component--Avanwave. So you have to install another waveform viewer to observe output results.
Good Luck!
 

Re: [help] Hspice installation

Use Cosm0s Sc0pe waveform viewer. It is excellent tool
 

linux Hspice installation

[Hi,

I tried to run hspice in a linux box but got the error message "...libc++-libc6..." that I couldn't figure out what it means. Can someone help me?

thanks,
 

Re: [help] Hspice installation

Contact Synopsys sale rep
**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top