Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

stepper motor wiring config

Status
Not open for further replies.
M

mara alaine

Newbie level 1
Joined
Jun 23, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
stepper motor configuration

please help me... i am new in electronics and i want to know the wiring configuration of a stepper motor. It has 5 wires colored: red orange, yellow, brown, and black. It is an Epoch motor that is 58 ohms. I cant find a datasheet on the net so please help me. :cry:
 

epoch stepper motor

You shal first of all measure resistance between pins. The resistance from one wire to all the other wires should be half the resistance (58 omhs in this case), while the other pairs should measure twice as much resistance.
This one wire should be connected to ground or voltage supply while the other wires can conect to ground one by one to regulate position. But it is many ways to achieve this.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top