Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Measuring the opamp's output swing

Status
Not open for further replies.
N

naalald

Full Member level 4
Joined
Dec 2, 2006
Messages
216
Helped
30
Reputation
54
Reaction score
5
Trophy points
1,298
Activity points
2,627
opamp output swing

When measuring the output voltage swing of an opamp, we should use a closed loop configuration. Measuring the opamp swing in open loop configuration does not make sense.
Is that right?
What is the best closed loop configuration to test the output voltage swing especially a fully differential opamp?
 

op-amp swing voltage

to measure output voltage swing use any topology you like...all you are trying to do is see how close it gets to positive and ngative rails.....or gnd if its single-supply.

did u see the book "how to use opamps" by E A Parr / Babani publisher.

its small cheap and to the point
 

how to measure output swing

Hi,
Thanks for your reply. Could you please send the link to download the ebook?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top