Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Higher Level Metal Usage - M2 vs. M6

Status
Not open for further replies.
S

sravan_iit

Newbie level 2
Joined
Jun 20, 2006
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
Higher Level Metal Usage

Hi,

I have one block which is separated by 500um, long length. Which metal i have to use M2 or M6.Assume no congestion and i can use both freely.

Sravan
 

Re: Higher Level Metal Usage

Is it connected power? I'd use the M6 if possible if it has a lower sheet resistance, otherwise it wont make any difference, unless you dont need M6?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top