Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is drill mark used for in Proteus Ares?

Status
Not open for further replies.
A

ahmedshakeel

Member level 2
Joined
Feb 7, 2007
Messages
42
Helped
4
Reputation
8
Reaction score
0
Trophy points
1,286
Location
Pakistan
Activity points
1,520
hi
I am new to PCB designing using (PROTEUS ARES) Please tell me what is the explanation of drill mark,in (PROTEUS ARES )
i have made a pad style with pad diameter of 80 thou,and drill hole dia of 40,i kept drill mark 40(thoug i dont know what it is used for ),also i have pads of 70,30
(default pads) with drill mark 25,if u view it on monitor screen u can c that 80 40 pad is bigger than 70 30,with obvious difference in drill hole,but on the contrary
if u take print out on paper,u can c that in 80, 40 pad the drill hole is too small,
plz help me with this,for now i am using 70 30 pad .
Shakeel
 

drill mark pcb

Hi shakeel,

Drill mark is used fir just indicating the particular drill suppose that you have given drill mark for drill of 40 and 30 as A and B respectively then the size of drill mark will be the size of letters A and B.
As far as drill of 80/40 being visible very small it might be due to scaling during Gerber generation.

hope this might help you.

Regards,
Ricky
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top