imranshoaib
Junior Member level 2
Hi,
I'm little confused with the stub position in stub tuning process. Let's say we have been given to match a load using single-stub whether short or open. I did both as an exercise and where I got myself stuck was the position of the stub. The query is: whatever the stub is? whether short or open, the stub position is not going to change; only length vary while switching from short to open or open to short stub.
Thanks in anticipation!
I'm little confused with the stub position in stub tuning process. Let's say we have been given to match a load using single-stub whether short or open. I did both as an exercise and where I got myself stuck was the position of the stub. The query is: whatever the stub is? whether short or open, the stub position is not going to change; only length vary while switching from short to open or open to short stub.
Thanks in anticipation!