Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The errors which u get after nanoroute are
1.Antenna Violation
2.short violation
3.spacing violation
The reason is the tool doesn't have the priority for the design rules thts y it will try to concentrate more on meeting the timing part then if u get any violation we need to do it manually or with the help of calibre after the design is completed
Bye take care
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.