Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Automate repetitive process of programming FPGAs, CPLDs?s

Status
Not open for further replies.
J

jbs87

Newbie level 6
Joined
Oct 23, 2007
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,389
At work, I have to program first the CPLD, then FPGA and finally load a bootlader and then WINDOWS CE onto a board. For the CPLDs, I use Xilinx Impact and for the FPGAs, I use Flashpro 3, for the bootloader I use a USB wriggler with the Macgraigor flash progammer, and finally for Windows CE, I use the hyperterminal. The process of programming each board is the same so I was wondering if there was some way I could run one file and it would run the rest of programs, doing the programming in sequence for me (maybe a .bat file, I'm not sure). Any help would be much appreciated.

Joshua
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top