Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It is very weak ground. If there is no powerful load on the board, sure you can. But it is not correct really. Try to find normal ground connection. I can't believe that it is not present.
I cannot believe it either, but in case it's true I would just scrape off some soldermask and solder wire to copper, because general polygon on PCB is probably connected to GND.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.