Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

lambda/4 line philosophy

Status
Not open for further replies.
Y

young.microwave.eng

Full Member level 3
Joined
Oct 22, 2008
Messages
150
Helped
11
Reputation
22
Reaction score
11
Trophy points
1,298
Activity points
2,310
hi
would you please describe me about the lambda/4 line philosophy that is used to isolate DC circuit and RF parts in microwave circuit design.my main question is about the length of the line.why it should be lambda/4.what happened if length reach the value less or grater that specified traditional value?
thanks in advance
 

The input impedance of a transmission line of length l terminated with load ZL is given by:
Zin=Z0(ZL+jZ0tan(Bl))/(Z0+jZLtan(Bl))

where, B=2*pi/λ.


the λ/4 line is known as the quarter-wave transformer and the input impedance of this line is given by (letting l=λ/4 in the above formula) :
Zin=Z0²/ZL

if you do short-circuit the end of the λ/4 line, its input impedance will be OPEN-CIRCUIT and vice versa.

Using this theoretical basis, we can use the λ/4 line to isolate the DC bias from RF section.

regards
 
Last edited:
Hi, I am a student and on a project... I am having a hard time understanding how lambda/4 transformers are used for the separation of DC biasing and AC signal. As lambda/4 transformers are used for impedance matching which basically just ensures maximum power transfer.
Any help would be welcome and could you also point me to a direction where I can do my research. Thanks in advance
 

Hi, lambda/4 section is used to isolate the Ac signal from the flowing into DC power supplies. check the configuration of a bias tee..the AC signal(RF) should see a high impedance (current always takes the least resistance path) towards the DC connection. So open ckt lambda/4 line looks like a short ckt at the point where it is connected.
 

Thank you so much was really helpful. I am also given to understand that seperating DC bias and Ac signal is also done by a standing wave method at high frequencies can you please explain how is done or again guide me in the right direction so that I can do the reasearch... again your help is greatly appreciated.
 

Check this weblink

**broken link removed**

It would be useful.

Thanks
venu
 

Thankyou so much for your help, I have grasped the concept now.
cheers!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top