Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Andrew,
Connections to power planes should be fairly automatic unless something is not being done correctly.
Your question is very vague. Could you explain a little more about the problem.
Choose a active layer, Click (Drafting toolbar), Click (Copper pour), right click, choose (rectangle), draw the shape, assign the shape to the net, Then (tools) (Pour manager) (Flood).
Under Options (Cntrl-alt-g) you can set up many options for this.
edaedaeda and beepstar, than kyou very much.. One last question, does anyone of you knows how to make a mesh ground and vdd pour in PADS? im so sorry, Im a newbie at PADS but I need to fabricate my board ASAP.
Set pour outline visible, type (po enter), toggles. Select outline, right click, properties, width (small).
Options (Cntrl-alt-g), grids, hatch (big).
Re-pour.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
