Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Gilbert Cell Mixer questions, how to make IP3 simulation

Status
Not open for further replies.
S

sampahbener

Newbie level 2
Joined
Dec 26, 2008
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
Gilbert Cell Mixer

Hi all


i have to desing a downconversion mixer with, RF freq = 2.3 GHz, LO freq = 2.2 GHz, and an output 100 MHz at IF

i have some problems designing my mixer

1. Is my BSIM3 model correct for this design
2. Is my DC bias circuit correct?
3. Is my input and output impedance matching correct?
4. in my simulation's result,, i have -51 for Conversion gain,, what should i do to make it positive
5. how to make IP3 simulation
 

Re: Gilbert Cell Mixer

In the mixer chapter you will find information about expected Gilbert cell performance


Microwave Circuit Design Using Linear and Nonlinear Techniques, Second Edition, by George Vendelin, Anthony M. Pavio, Ulrich L. Rohde, published by John Wiley & Sons, New York, NY, May, 2005, ISBN 0-471-41479-4.
 

Gilbert Cell Mixer

somebodyyy,,, help,, give some advice for me
 

Gilbert Cell Mixer

Your circuit is wrong.You drive LO to only one MOS, other one ( MOSFET9) is not driven.However, MOSFET9 and MOSFET16 should be both driven by the same LO signal.
I have simply corrected your circuit and the Power Gain that should be simulated as Pout/Pin NOT by S-Parametrs !! is found as 4.98dB as mentioned in pdf file.

Investigate your circuit carefully, there might be some other type errors..
Good Luck
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top