Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

0-10[Vcc] or -10-10[Vcc] Source

Status
Not open for further replies.
V

venix

Member level 4
Joined
Mar 20, 2008
Messages
73
Helped
10
Reputation
20
Reaction score
3
Trophy points
1,288
Location
EU
Activity points
1,702
Hello everybody!
I need a schematic for a source that can provide 0-10[Vcc] or/and -10-10[Vcc] very precisely.The accuracy of the source must be at least 0.01[Vcc].I need this source to simulate sensors that have the output in this range.
Regards!
 

can you explain? not clear
what do you mean 0-10 vcc?
 

I think a voltage calibrator circuit is what venix is looking for.
Try here, I think this may be what you want.

**broken link removed**

Bob
 

    V

    venix

    Points: 2
    Helpful Answer Positive Rating
Hi, u can use LM317 for your source: Vi ias about 15VDC, Vout is 0 to 10VDC depend on variable resistor on circuit.
 

    V

    venix

    Points: 2
    Helpful Answer Positive Rating
The accuracy of the source must be at least 0.01V. Are you sure???

In my experience, LM317 produces voltage tolerance at least 0,05 Volt.

Maybe the article from DrBob13 will help you. But your source accuracy limit still hard to be realized.
 

    V

    venix

    Points: 2
    Helpful Answer Positive Rating
The 10 mV accuracy for a 0 - 10 V calibrator is a usual value, it would be achieved by many general purpose calibrators, e g. a Keithley 2400 SourceMeter. Design of such an instrument respectively a fixed range basic circuit requires some knowledge of analog electronics anyway.

Obviously, a precision reference is necessary, also precision resistors and amplifiers. As many good DAC have an absolute error less than 1 LSB, a design based on a 12 - 16 bit DAC seems practicable.
 

    V

    venix

    Points: 2
    Helpful Answer Positive Rating
Hello all!
DrBoB had right,what I mean is a voltage calibrator.
Thanks for your reply

Best regards!
Venix
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top