Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Use any four pins of a port say P1-0 to D0, P1-1 to DIn, P1-2 to SCK and
P1-3 to Chipselect. Connect IRQ to pin P3-2 or P3-3. Set P1-0 to make it an input bit.
Regards, Laktronics
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.