Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

can cadence ic5141 utilize the stand cell library to layout?

Status
Not open for further replies.
S

swgchlry

Member level 4
Joined
Dec 8, 2003
Messages
69
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
718
I'm designing some very small digital circuits, <100 gates. Could ic5141 read the tsmc stand cell library to extract the cells and instantiate these cells in layout editor? If can't, is there a simple way to get the layout without employee Synopsys DC and Canence P&R Tools?
 

basically you can instantiate the layout cell into your layout. However, your layout library should provide a full layout view (all GDS layers) in order to get all extracted devices.

If the library only provide the blackbox view, you again extract the spice from the layout, but you can get the subcircuit level netlist.

hope this is helpful.

mm
 

    S

    swgchlry

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top