Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

The RF cable for VNA8510 source 83651?

Status
Not open for further replies.
W

winglj

Full Member level 4
Joined
Feb 21, 2005
Messages
195
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,063
Hi, everyone. I am wondering whether there are someone using the HP vector network analyzer 8510 system. My cable for the RF synthesizer 83651 has some trouble, and I am just going to replace it. So what is the model or part number for that RF cable? Can the PC-2.4 cable be used for this output? Thanks.
 

That cable do not need particular phase stability, so high performance cable are not needed. But 2.4mm coax cable assembly are almost all performant and expensive.
The only low cost alternative is the semi-rigid coax.

Also choose the path lenght as short as possible in order to get at the out the highest power level.


If the original semi-rigid has a broken SnPb solder joint, You may try to repair it before buy a new one.
 

    W

    winglj

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top