Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how does a mos-fet transistor reads

Status
Not open for further replies.
R

rascabuche

Member level 3
Joined
Jan 29, 2006
Messages
54
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,607
i need some help. can anyone tell me how to read and obtain the proper measurements of a fet with my DMM(digital multimeter). Have a fet K2141 , but dont know what reading to expect or atleast to know if it is shorted.
any help appreciated.

Ras
 

As per the data sheet diagram posted, the first pin is the gate, the second is the drain and third source. When you measure with your dmm, in the diode position,you should see a junction between drain and source. If it shows short or 000, then the mosfet is blown. The data sheet also says protection diode on the gate. so repeat the process for the gate.
 

    R

    rascabuche

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top