Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Ripple in S21 of a coaxial cable

Status
Not open for further replies.
N

noori.re

Member level 1
Joined
Sep 19, 2011
Messages
33
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Location
Dresden, Germany
Activity points
1,557
I am measuring S21 and S11 of a coaxial cable using VNA. I expected to see a S21 that decreases by frequency but has some ripply behavior. It means that in some regions S21 is improving by increasing the frequency. Does anyone know the reason for this behavior? At first, I thought it should be related to non-ideal input impedance but marker number 5 in the figure below rejects this idea.

1656924240494.png
 

Sort by date Sort by votes
I presume that the Calibration was done well.
The cable is bad so Characteristic Impedance is waving due to mechanical inconsistency or inner conductor has a crack. Other option your VNA has not been calibrated very well or it has some problems.
Have you ever checked the cable quality or characteristic impedance ?? Has it visible faults ??
 
Upvote 0 Downvote
Standard coax impedance spec is 50 +/- 2 ohm, reflections at both ends can worst case generate a ripple in the observed order of magnitude.

I would expect a complete specification anyway (cable type, length, instrument, calibration).
 
Upvote 0 Downvote
BigBoss said:
I presume that the Calibration was done well.
The cable is bad so Characteristic Impedance is waving due to mechanical inconsistency or inner conductor has a crack. Other option your VNA has not been calibrated very well or it has some problems.
Have you ever checked the cable quality or characteristic impedance ?? Has it visible faults ??
Click to expand...
The caliration using ideal kit is done and everythins is perfect with ideal kit through mode. The quality of cable seems good no visible mechanical problem. I supposed that the measurement is correct because Im getting almost similar result when measuring with R&S CMW500 also.
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top