Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] HF3D error

Status
Not open for further replies.
R

Rosalinekavitha

Member level 1
Joined
Nov 11, 2019
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
259
hi,
I have designed spiral coil over fr4 substrate using driven terminal. while simulating the coil, the following error occurs.
" Port 1 does not have a solved inside material on either side..". I checked with solved inside box and the port also matches with terminals. but still the error persists?? what may be the other causes for the error??
 

Attachments

  • Capture.PNG
    Capture.PNG
    57.1 KB · Views: 150

Although it's hard to surmise what the issue could be from that figure, I might guess it is related to your domain setup. What material surrounds the port? It looks like FR-4 is below the port in the picture, what is above it?
 
Yes .. you are correct. The feed is not properly united to the spiral properly and hence the material assignment and solved in check up doesnt work.. even though they are explicitly shown
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top