Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

3 Phase IGBT inverter voltage

Status
Not open for further replies.
R

Ranbeer Singh

Full Member level 5
Joined
Jul 30, 2015
Messages
259
Helped
22
Reputation
44
Reaction score
22
Trophy points
1,298
Location
Faridabad India
Activity points
3,266
Hello,

I was founding a Three phase IGBT inverter module for 3 phase motor drive and found FSAM10SH60A IGBT module. In it's datasheet page no.5 says

Supply voltage = 450V (Applied to DC-Link)
Supply voltage (Surge) = 450V (Applied between P & N)
Collector Emitter voltage = 600V


These given voltage data is not matching with my voltage. I am not understanding that Is is write and wrong component for my need?
Second question is What is VCC (control supply) current of this module?

Please help
 

Expensive, but usefull chip.
Max AC voltage = Max DC voltage * sqrt(2)
At the top of the Electrical Characteristics Control Part page on the datasheet it says VCC is 26mA.
 
The output line to line voltage based on DC link (without third harmonic tricks) is:

Vline to line RMS = VDC/2/√2*√3

For a 600V DC link this comes out as being 367V. With the addition of third harmonic of the fundamental you can squeeze another 15 -> 20% of that which comes out as being about 440V best case.
 
Thanks your replies,
The output line to line voltage based on DC link (without third harmonic tricks) is:

Vline to line RMS = VDC/2/√2*√3

For a 600V DC link this comes out as being 367V. With the addition of third harmonic of the fundamental you can squeeze another 15 -> 20% of that which comes out as being about 440V best case.
Click to expand...

My DC link supply voltage according to 400v/3P is 563vdc. I am not understanding why are you calculating Vline to line RMS?

- - - Updated - - -

Oh,
I have understood it. It's ok. I was not considering voltage according to IGBT output.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top