Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[General] Interface between parallel port and USB printer using microcontroller

Status
Not open for further replies.
S

sandeepanand.62

Newbie level 2
Joined
Apr 22, 2014
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
30
Dear All,
I am working on a medical equipment. This device consists of a sensor , a few micro switches and some ports. One of the micro switch is to print the data from sensor. The printer used here is dot matrix. So the port to connect it is parallel port. I have to connect a USB printer to this device. I can add some extra hardware to make the data from that board to USB compatible. If anyone knows about this please suggest me some ideas. I need the micro controller name (if needed for this) and circuit and the code. please help me......

Regards,

Sandeep
 

Thanks for all your reply...
The printer output needs both text and graphics. I already searched for the USB host. But I want to know whether the data given to the dot matrix printer holds any printer commands ? Will it support the USB printer ?
 

sandeepanand.62 said:
Thanks for all your reply...
The printer output needs both text and graphics. I already searched for the USB host. But I want to know whether the data given to the dot matrix printer holds any printer commands ? Will it support the USB printer ?
Click to expand...
yes it does run it as EPP(enhanced parallel port)
for more details about it (beyond logic .org)

Zeyad
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top