Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

layout of one end joined coupled line (in ADS)

Status
Not open for further replies.
maktoomi

maktoomi

Member level 2
Joined
May 19, 2012
Messages
46
Helped
4
Reputation
8
Reaction score
5
Trophy points
1,288
Location
India
Activity points
1,651
Hi,
I have a coupled line section joined at one end as shown in part(1) of the attached figure. It also shows the corresponding layout.
To mimic this, I made a setup as shown in part(2) of the figure. Part(3) shows the corresponding layout generated by ADS. And it doesn't matches with that shown in part (1).
Kindly help me out to figure out the mistake.
This is my first ever coupled line layout.
Couple_layout.jpg

Thanks in advance.
 

Hi
why don't you directly use ADS momentum for your work?
I mean directly use momentum and draw in the layout..
 
Last edited:

Thanks Jamal, I automatically generated layout from schematic (without joining the ends) and in the layout window I connected them manually. I don't know much about manual layout. It would be great someone could share some tutorial .
 
You're welcome buddy.
If you go in layout section of ADS you can easily draw your structure, attached file is a very short tutorial, you can find more through its help and some useful videos...

ADS.jpg
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top