Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Single phase BLDC doesnt exist?

Status
Not open for further replies.
T

treez

Guest
**broken link removed**

...on this page is a "single phase BLDC motor driver IC", -surely there is no such thing, ?. I mean, there needs to be at least three phases so that you can rotate the motor by pulsing from one phase to the next round the circumference of the stator?
 

thanks, I see it is possible, but it strikes me that it could just come to a stop with both halves of the coils pulling it the opposite way.
Anyway, my other query is how does one change the speed of a dc 'brushed motor.....and your article confirms that its done by changing the voltage....so I cannot understand why we are being told to vary the speed by varying the current.
Do you know why one might feed a dc brushed motor with a controlled current source...I thought it would just mean more commutator sparking?
 

Either voltage or current controllers can be used. In my limited experience, most the the chips I saw for brushed motors were current controlled. It was a few years ago when I did any of that, though. Here is a presentation by Microchip that summarizes the differences:

https://www.microchip.com/stellent/groups/SiteComm_sg/documents/Training_Tutorials/en527885.pdf

The speed of control and cycle-by-cycle response seem to be the major advantages of current control that were mentioned in datasheets.

John
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Sorry bit I didn't explain myself properly. I am not talking about whether the smps that supplies the dc motor is in voltage mode or current mode. I am speaking about actually regulating the current flowing to the dc motor, or regulating the voltage applied to the dc motor......you first article states that one controls a dc motor by varying the votage applied to it...not the current.
Has anyone ever heard of controlling a brushed dc motor by varying the current supplied to it?.....I am sure it never occurs, and is a bogus method which our company has told us to do just to proove that we are muppets?
 

In Gieras/Wing, Permanent Magnet Motor Technology - Design and Applications, I find a paragraph about single phase BLDC motor design. They are made e.g. with non-uniform air gap to generate a starting torque. They are basically suited as a replacement for single phase AC motors (e.g. shadow pole type) with considerable better efficiency. Similar to the AC motors, they can only serve for applications without much static friction.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
I recognized the title was SMPS, but the advantage of fast response is not limited to SMPS. One of the chips I used was the LT1158 in a half-bridge, brushed motor controller:

http://cds.linear.com/docs/en/datasheet/1158fb.pdf

Note, the same point is made for that chip. I guess that datasheet doesn't say cycle-by-cycle per se. If that phrase is important, I am sure I can find a datasheet for another chip that uses it.

John
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
thanks, and with the top fet on all the time, i presume that gives maximum speed to the brushed dc motor?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top