Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Setting of TEM mode for a waveguide port in CST MWS

Status
Not open for further replies.
M

Mona7150

Member level 1
Joined
Nov 9, 2013
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
249
HI,

I am using a waveguide port to excite my structure in CST. I keep the no. of modes =1 which it by default takes as TM mode. But I want to have TEM mode. How is it to be done ?


Thanks
 

In my knowledge, TE mode with the angle of incident wave =0, that is TEM mode.
 

Hi Mona7150,
You will define the modes number, e.g how many modes are simulated, but what will define the propagating mode (TE, TM or TEM) will be your geometric structure. If your structure is a hollow waveguide, you will not see TEM modes, because the boundary conditions do not allow. Otherwise, if your structure is a coaxial waveguide or a two or more wire structure, then TEM mode will be the first propagating mode. In CST Help you can see some examples could be useful.
Best regards.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top