Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Fingers and Multiplier concept in schematic and Layout (CADENCE)

Status
Not open for further replies.
K

kenambo

Full Member level 6
Joined
Feb 26, 2012
Messages
393
Helped
52
Reputation
104
Reaction score
48
Trophy points
1,308
Location
India
Activity points
3,859
Hi,

I found fingers and multiplier options available in schematic and layout....{cadence TOOL)

and i tested a MOS with 2 fingers and 2 multipliers ,, it shows similar results....

What is the difference Between fingers and multipliers?

Do these affect the characteristics of the MOS we use?

does this depend on pdk?

thanks to all...
 

Fingers: Two poly gates in a single transistor with a source and a drain terminal
Multiplier: Two transistors, each with a single poly gate and a source and a drain terminal

The setting has an effect on the MOS characteristics. For example the LOD (length of diffusion) effect. This effect will be visible when designing differential pairs and current mirrors, however I am not sure how well it is modeled from process to process.
 
yes ofcourse ... but when i am doing layout, i can just take 2 moses and overlap both drain regions and short circuit two sources & two gates....
like S G D G S...

then this is same as mos with 2 fingers .. or any difference between this and mos with 2 fingers...

thanks for ur reply...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top