Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Prime time can write out file

Status
Not open for further replies.
E

ee1

Full Member level 2
Joined
May 31, 2011
Messages
120
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
2,036
Prime time can fix setup, hold and drc and write out a tcl script to run in icc..

---------- Post added at 06:26 ---------- Previous post was at 06:24 ----------

Pls delete this post. It was submited by excident.
 

Prime time is a Timing analysis tool . It doesn't fix any timing violations , only reports timing information.
 

Primetime can do setup and hold fixing using "fix_eco_timing" command and suggest the changes.
You can write the changes suggested by primetime to fix setup/hold violations using "write_changes" command.
You can source the tcl file generated by "write_changes" command directly into ICC
 

Prime time doesn't fix violations , its a analysis tool. The command "fix_eco_timing" will give suggestions about violations , but PT doesn't rectify violations itself. To rectify it , you can source that suggestions into ICC , as u have mentioned above.

Correct if i am wrong !!

chiplogic said:
Primetime can do setup and hold fixing using "fix_eco_timing" command and suggest the changes.
You can write the changes suggested by primetime to fix setup/hold violations using "write_changes" command.
You can source the tcl file generated by "write_changes" command directly into ICC
Click to expand...
 

yes you are correct.."fix_eco_timing" gives the suggestions to fix setup or hold violations and you can apply those ecos in ICC and fix the setup and hold violations
jeet_asic said:
Prime time doesn't fix violations , its a analysis tool. The command "fix_eco_timing" will give suggestions about violations , but PT doesn't rectify violations itself. To rectify it , you can source that suggestions into ICC , as u have mentioned above.

Correct if i am wrong !!
Click to expand...
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top