Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] CST MW VBA code to update parameters

Status
Not open for further replies.

ghost90

Newbie level 4
Newbie level 4
Joined
Feb 12, 2012
Messages
5
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,309
hey all
i have problem with CST VBA code
i want to update the parameters and start the T-Solver with the new updated parameters with VBA
i try parameters sweep codes and the new sequence have been add but when i use this code
Solver.Start
its just getting the results from the old parameters :sad: nd cancel the the sequence
my main goal is to change the parameters and run T-Solver all by VBA so i can make link between Matlab nd the CST
so any one can help me please ?
thank you all ..
 

Hello ghost90

Have you found a solution to your problem?
I am facing the same issue, so I would be thankful to help and advice.

Best regards,

hey all
i have problem with CST VBA code
i want to update the parameters and start the T-Solver with the new updated parameters with VBA
i try parameters sweep codes and the new sequence have been add but when i use this code
Solver.Start
its just getting the results from the old parameters :sad: nd cancel the the sequence
my main goal is to change the parameters and run T-Solver all by VBA so i can make link between Matlab nd the CST
so any one can help me please ?
thank you all ..
 

@andr1985
yes i found the solution ... where u stop ?
 
  • Like
Reactions: nahid

    nahid

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top