Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to configure circuit for octal transceiver such that default V at pins is 0 V.

Status
Not open for further replies.
V

vaia-riseng

Newbie level 6
Joined
Dec 28, 2011
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,374
Hi, I am using octal bus transceiver SN74ls245. I want the pins to have a default output voltage of 0 Volts when there are no inputs on both sides. I thought this would be the case but when I attach the tranceiver to a power supply, there is a 3.4 V output voltage on all pins (a-b). How can I do this without enabling the E input? Thanks very much! :)
 

If the 3-state outputs are in the high impedance state you can use pull down resistors to ground. The value of the resistor is defined by the time you want the output reaches 0V after going into 3-state. Of course, a low resistor value will be a load for the output driver. Check therefore the max. spec for the output.

Enjoy your design work.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top