Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My friend told me that the PADS is the best EDA software.
But when i used for the first time,i disappointed.
I think Orcad is better.
My question:
Which one is best in PADS,ORCAD, Protel?
Please tell me.
Ths
unspecified or unsupported version of ascii file
Hello
I creat the netlist(Others-padspcb.dll) in orcad.
But when i import the netlist into the pads(2005).
it is warning:
"
*Unspecified or unsupported version of ASCII file
*PADS-PCB*
**INPUT WARNINGS FOUND**"
I don't know the reason.What's...
Hello!
I 'm using PADS firstly.
I puzzle the Layer_25 of VIA footprint.I used ORCAD in which there was not the layer-25.
What is Layer-25?
Who may tell me?
Ths
Regards
Fourier
Hello!
I have a problem.
It's that What is the difference between "Page" and "Block/Bank" in EEPROM.
It described that " The 2K is internally organized with 32pages of 8 bytes each"in the
datasheet of AT24C02.
Regards
Ths.
I'm interested in "several experiments and analytical papers written in the past few years that disprove the myth that right angles cause impedance mismatch, radiation, etc, on high speed boards. "
But idon't search the papers.Who can give these literatures?
THS
Regards.
fourier
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.