Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
give some more from the exsample-do you mean :
1 stored command in MCU to call a phome nomber ,at event .
2 sending commands from PC -MCU - sell phone?
or else?
there is a two lines :CAN HIGH and CAN LOW ,and in different cars is a different situation.In the disel cars with VP44 Pump on the EDC of a pump is 2 lins ,for cooler in BMW .In some cars is use optic fiber for comunication.
The driver L293 ,D/E/DNE ,current draw like hell!!!Abaut 50mA in stan-by and 80mA in 1 Ch ,wit 2 ch 100mA!If you without L293 on the pin of the MCU hawe 5 V -then the problem is in power suplay.If not try wit other MCUwithout!!!!! L293 how the pin state is. In my expirianse with l293 i had 2...
Well for VAG gruo use VAG-COM KKL inteface to USB -works fine for Audi,seat,shkoda,seat.VW Software from Ross tech.With this adapter you can use it for more cars and software-fiat lanchia,alfa,BMW and more.For best result you mast !!!use software for this car!
You can try programmer from here :**broken link removed**
Are you sure that the MCU is OK?Change the HC wit LS in the programmer ,some times do not work correct.Or try the simple programmer like this **broken link removed**
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.