Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In a multi-master system, if one master(M1) accesses a slAve(S1), and S1 pulls hreadyout low.
Then another master(M2) accesses S1. Should M2 see hready low at the addr phase or data phase?
Or S1 pulls hreadyout low itself due to initialization. M1 should seen hready low at addr phase?
When I used the sighoff_opt command in IC Compiler,
An error occurred:
It is not recommended to use classic router commands after Zroute commands. (RT-302)
How to use Zroute rather than Classic router?
- - - Updated - - -
Solved. set_route_mode_options -zroute true
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
