Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm trying to Convert i.mx6rx schematic from altium to orcad,
I Did changes in SDt.cfg file to link to my working library, but to no anvil.
Also, Using altium tried saving the project to .dsn format, but doesn't work
I get the following error:
"""""
""""""
I understand its searching for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
