Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by yzcom

  1. Y

    bandgap floor planning

    The picture shows the two pnp(left down corner), MOSFET in the opamp. And it shows part of the resistor array(up right).
  2. Y

    bandgap floor planning

    This is a reference...
  3. Y

    pass the commands from VC++ program to the command window i

    cadence skill reference manual This sounds so complicated. Is this easy to complete ?
  4. Y

    How to convert Dracula rule file Calibre rule file?

    DIVA TO CALIBRE You can write a "perl" script to convert diva command file to dracula command file according their command syntax.
  5. Y

    Why when I compile pcell it says: no parameter in this cell?

    Re: compile pcell If you don't assign any parameter, it is not necessary to compile a pcell. Since you compile pcell(parameterized cell), you are sure to assign some parameters -- such as gate width, gate length etc. Tools - > Pcell then "pcell" menu appears. Clock "Pcell" menu, select the...
See more

Part and Inventory Search

Back
Top